Volkswagen Golf Service & Repair Manual: Removing and installing fuse holder A -SA-
| – |
Remove fuse holder B
→ Chapter. |
| – |
Take securing bar -4- out of
fuse holder B upwards. |
| – |
Release retaining tab -1--arrow-
and remove fuse holder A -2-
downwards from fuse holder B -3-. |
| Installation is carried out in the reverse sequence. |
|
|
|
Removing
–
With ignition switched off, disconnect earth cable from
battery
→ Chapter.
...
Removing
–
With ignition switched off, disconnect earth cable from
battery
→ Chapter.
– ...
Other materials:
Rear axle
Overview - rear axle, torsion beam axle
I -
→ Chapter „Axle beam“
II -
→ Chapter „Suspension strut, shock absorber, spring“
III -
→ Chapter „Wheel bearing assembly, trailing a ...
Assembly overview - front side airbag
1 -
Backrest frame
2 -
Hook
For attaching side airbag to backrest frame
3 -
Front side airbag
Driver side: with side airbag igniter on driver side -N199-
Front passenger side: with side airbag igniter o ...
Releasing gas and draining front gas-filled shock absorbers, conventional
shock absorbers
Clamp gas-filled shock absorber vertically in vice, with
piston rod pointing downwards.
WARNING
Safety goggles must be worn when drilling.
–
Dril ...
© 2016-2024 Copyright www.vwgolf.org
Removing and installing fuse holder B -SB-
Removing and installing relay and fuse carrier behind dash panel, LHD
vehicles