Volkswagen Golf Service & Repair Manual: Removing and installing fuel gauge sender -G-, vehicles with four-wheel drive

Volkswagen Golf Service & Repair Manual / Fuel supply system - Petrol engines / Fuel supply, gas operation / Senders and sensors / Removing and installing fuel gauge sender -G-, vehicles with four-wheel drive

Removing

–	Remove fuel delivery unit → Chapter.

–	Disconnect connector -4- from right flange.

–	Disengage and move clear electrical wiring at retainer -arrow-.

–	Release locking lugs -1 and 2- from tabs.

–	Pull out fuel gauge sender -G--3- upwards.

Installing

Installation is carried out in the reverse order; note the following:

–	Insert fuel gauge sender -G- into guides on fuel delivery unit and press down until it engages.

–	Route and attach electric cables on fuel delivery unit.

–	Install fuel delivery unit → Chapter.

Removing and installing fuel gauge sender -G-, vehicles with four-wheel drive

Removing and installing fuel gauge sender -G-, vehicles with front-wheel drive

Removing – Remove fuel delivery unit → Chapter. – Note colour assignment of cables -1- ...

Removing and installing fuel gauge sender 2 -G169

Special tools and workshop equipment required Removal wedge -3409- ...

Other materials:

Removing and installing right temperature flap control motor -V159-, RHD vehicles
Special tools and workshop equipment required Vehicle diagnostic tester Bit ratchet First carry out the following work: – Switch off all electrical consum ...

Assembly overview - rear seat backrest
1 - Rear seat backrest Allocation → Electronic Parts Catalogue Removing and installing → Chapter 2 - Lock For rear seat backrest Assembly overview → Chapter 3 - ...

Assembly overview - data bus diagnostic interface
1 - Electrical connector For data bus diagnostic interface -J533- 2 - Data bus diagnostic interface -J533- Removing and installing → Chapter 3 - Bolt Spe ...