Volkswagen Golf Service & Repair Manual: Removing and installing front footwell illumination bulb -L151-/-L152-

Note

If an LED front footwell light is faulty, the entire light must be renewed.

Removing

–	Remove front footwell light -K268-/-K269- → Chapter.

–	If necessary, lever off heat shield -2- on both sides at arrows -A-.

–	Remove heat shield -2- from footwell light -1-.

Removing and installing front footwell illumination bulb -L151-/-L152-

–	Pull bulb -1- out of bulb holder -2- on reverse side of glove compartment light.

Installing

Installation is carried out in the reverse sequence.

–	Test functionality.

Removing and installing front footwell illumination bulb -L151-/-L152-

Removing – Using a flat screwdriver, press in locking lug -1- at point indicated by arrow - ...

Removing – Remove front door trim panel → General body repairs, interior; Rep. gr.70. ...

Removing and installing bonnet lock, LHD vehicle
Special tools and workshop equipment required Removing Torque wrench -V.A.G 1331- – Open bonnet. – Remove Bow ...

Removing and installing high-voltage heater (PTC) -Z115- / high-voltage heater (PTC) -J848
Special tools and workshop equipment required Commercially available Torx socket bit “TS30H” with hole in front face Hose clamps, up to 25 mm -3094- Engine bung set -VAS 6122- ...

Removing and installing footwell vent temperature sender -G192
Special tools and workshop equipment required Removal wedge -3409- Vehicle diagnostic tester Removing Note Only o ...