Volkswagen Golf Service & Repair Manual: Removing and installing front body acceleration senders -G341-/-G342-
Special tools and workshop equipment
required |
|
|
|
Torque wrench -V.A.G 1410- |
– |
Pull seal off entire length of plenum chamber cover. |
|
|
|
– |
Lift plenum chamber cover -1-
not more than 60 mm. |
|
|
|
– |
Release electrical connector -1-
and pull off. |
– |
Remove front body acceleration sender. |
Install in reverse order of removal, observing the
following: |
|
|
|
– |
Insert front body acceleration sender-1-
so that connector -arrow- points to
rear (opposite to normal direction of travel). |
– |
Tighten bolt -2- for front body
acceleration sender-1-. |
Installation position: angle tolerance
-a- is ±10°. Installation position of front body
acceleration sender may deviate by this angle along the
longitudinal axis of the vehicle. |
– |
Perform basic setting of wheel damper electronics
→ Vehicle
diagnostic tester. |
|
|
|
Component |
Specified torque |
Front body acceleration sender
to body |
8 Nm |
Special tools and workshop equipment
required
Vehicle diagnostic tester
Removing
Location: electr ...
Special tools and workshop equipment
required
Torque wrench -V.A.G 1410-
Re ...
Other materials:
Removing and installing head restraint
Removing
–
Press release button -3- for
height adjustment on head restraint guide
-4- in -direction of arrow-.
–
At the same time pull head restraint
-1- out of rear seat backrest -2-
...
Removing and installing washer fluid reservoir
Special tools and workshop equipment
required
Drip tray
Note
Removal and installation of washer fluid reservoirs with
headlight washer system are described. Removal and installation
of washer f ...
Removing and installing exterior mirror
Special tools and workshop equipment
required
Torque wrench -V.A.G 1783-
Note
Removal and installation are described only for the le ...
© 2016-2024 Copyright www.vwgolf.org