Volkswagen Golf Service & Repair Manual: Removing and installing front bass loudspeakers -R21-/-R23

Volkswagen Golf Service & Repair Manual / Communication / Infotainment / Sound system / Removing and installing front bass loudspeakers -R21-/-R23

The front left bass loudspeaker -R21- and the front right bass loudspeaker -R23- are located in the front doors (bottom).

Note

Removal and installation are described for the left side. Removal and installation on the right side are carried out in the same way.

Removing

–	Switch off ignition and all electrical consumers, and remove ignition key.

–	Remove door trim panel → General body repairs, interior; Rep. gr.70

–	Release locking mechanism of connector on front left bass loudspeaker -R21- in direction of arrow.

–	Pull connector -1- out.

Removing and installing front bass loudspeakers -R21-/-R23

–	Drill out rivet -1- with a suitable drill bit.

–	Remove front left bass loudspeaker -R21-.

Caution

It is essential that all swarf be removed from the door because otherwise corrosion damage will occur.

Immediately rectify any paintwork damage caused when drilling out the rivets.

Installing

Install in the reverse order of removal. When doing this, note the following:

Note

When installing loudspeaker, secure it with special blind rivets (note part number).

Removing and installing front bass loudspeakers -R21-/-R23

Removing and installing rear treble loudspeakers -R14-/-R16-, 4-door

Rear left treble loudspeakers -R14-/rear right treble loudspeakers -R16- are located in rear door trim panels. Note If the trebl ...

Removing and installing rear bass loudspeakers -R15-/-R17-, 2-door

Rear left bass loudspeakers -R15-/rear right bass loudspeakers -R17- are located in side panel. Note Removal and installation are desc ...

Other materials:

Technical data
Allocation gearbox - engine Golf 2013 ►, Golf Estate 2014 ► Always take account of the gearbox code if spare parts are required for a repair. ...

Overview of fitting locations - entry and start authorisation system, LHD vehicles
1 - Immobiliser reader coil -D2- Removing and installing → Chapter 2 - Control unit for electronic steering column lock -J764- Removing and installing → Running gear, axles, steering ...

Detaching fibre optic cable from cable harness connector
Removing – Pull fibre optic cable connector off the relevant control unit. – Release the locking mechanism in fibre optic cable connector -1- by pressing it. – ...