VW Golf manuals

Volkswagen Golf Service & Repair Manual: Removing and installing fresh air/recirculated air, air flow flap control motor -V425-, RHD vehicles

Volkswagen Golf Service & Repair Manual / Heating, air conditioning / Air conditioner / Control motors / Removing and installing fresh air/recirculated air, air flow flap control motor -V425-, RHD vehicles

Special tools and workshop equipment required
Vehicle diagnostic tester
  Note
The control motor has end stops with integrated limit switches instead of a potentiometer.
First carry out the following work:
–  Switch off all electrical consumers.
–  Switch off ignition.
–  Remove ignition key.
Removing
–  Remove dash panel central tube → General body repairs, interior; Rep. gr.70.
   
–  Remove bolts -2-.
–  Remove fresh air/recirculated air, air flow flap control motor -V425--1- from air intake duct.
–  Disconnect electrical connector -3-.
Installing
 

Removing and installing fresh air/recirculated air, air flow flap control motor -V425-, RHD vehicles

Installation is carried out in the reverse order. When installing, note the following:
  Note
Check operation of flaps and hinge mechanism before fitting.
Make sure levers and shafts are properly fitted in the mounts.
–  Fresh air flap must be set to “open” position, in order to allow fresh air to flow into the vehicle.
The operating shaft -2- must be on the stop -1--arrow- as shown.
  Note
If the control motor operating shaft is not on the “fresh air mode” stop, rotate the receptacle in the control motor.
–  Switch on ignition, connect respective control motor to vehicle wiring harness and select a setting on operating and display unit to set control motor to desired position (e.g. mid-position). Wait until control motor has moved to desired position and switch off ignition.
–  Position the control motor on the air intake box. The operating shaft must engage in the receptacle.
There must not be any play in the connection between the operating shaft and receptacle.
  Note
If the bolts cannot be fitted, the control motor is not completely seated on the housing.
–  Route wiring harness so that it cannot come into contact with any moving parts (e.g. actuating arm on control motor).
–  Read event memory, and clear any entries displayed. Then, perform “basic setting”vehicle diagnostic tester in “Guided fault finding” mode.
–  As a final step, check operation of heater and air conditioning system.
Specified torque
→ Chapter „Assembly overview - heater and air conditioning unit“
Assembly overview - dash panel central tube → General body repairs, interior; Rep. gr.70.
Assembly overview - dash panel → General body repairs, interior; Rep. gr.70.
 

Removing and installing fresh air/recirculated air, air flow flap control motor -V425-, RHD vehicles

Removing and installing fresh air/recirculated air, air flow flap control motor -V425-, LHD vehicles
Special tools and workshop equipment required Vehicle diagnostic tester First carry out the following work: ...

Removing and installing front air distribution flap control motor -V426-, LHD vehicles
Special tools and workshop equipment required Vehicle diagnostic tester First carry out the following work: ...

Other materials:

Assembly overview - drive shaft, triple roller joint AAR3300i
1 -  Bolt Renew after removing Loosening and tightening → Chapter Before fitting, clean the threads in the CV joint using a thread tap. 200 Nm +180° 2 -  ...

2-pack HS mixture surfacer
Designation:   2-pack HS mixture surfacer -LGF 810 150 A4-, white   2-pack HS mixture surfacer -LGF 810 151 A4-, black   2-pack HS mixture surfacer -LGF 810 152 A4-, red ...

Assembly overview - steering rack, left-hand drive
  Caution The following work must not be performed while the universal joint is separated from the steering rack: Connect battery. Switch on ignition. Turn steering rack. ...

© 2016-2024 Copyright www.vwgolf.org