Volkswagen Golf Service & Repair Manual: Removing and installing fresh air intake, RHD vehicles
– |
Remove plenum chamber cover
→ General body repairs, exterior; Rep. gr.50. |
– |
Remove cover for fresh air intake
→ Chapter. |
– |
Remove air quality sensor -G238- (only on vehicles with
Climatronic)
→ Chapter. |
|
|
|
– |
Remove fresh air intake -1-
from plenum chamber. |
Install in reverse order. |
– |
Align air intake grille on metal collar. |
– |
Hold air intake grille and screw on outer nut half-way onto
welded stud. |
– |
Screw on nut on opposite side. |
Note
The seal -2- must be properly
seated on air intake grille. |
Water may enter the fresh air intake if the grille is
damaged or not properly fitted. This may result in complaints
about odours from the heater and air conditioning system and/or
about moisture in the vehicle. |
|
|
|
Component |
Specified torque |
Nut |
3 Nm |
Removing
–
Remove plenum chamber cover
→ General body repairs, exterior; Rep. gr.50.
–
...
Note
The illustration shows a left-hand drive vehicle. The
removal and installation procedure is identical for both
versions.
...
Other materials:
Assembly overview - starter (vehicles with manual gearbox)
1 -
Starter -B-
Removing and installing
→ Chapter
2 -
Double stud
Specified torque: 80 Nm
3 -
Earth cable
Depending on vehicle equipment
...
Removing and installing exterior mirror
Special tools and workshop equipment
required
Torque wrench -V.A.G 1783-
Note
Removal and installation are described only for the le ...
Starter button
Fig. 129 In the lower part of the centre
console: starter button for the Keyless Access locking and starting system
Fig. 130 Emergency start function in vehicles
with Keyless Access
First read and observe the introductory information
and safety warnings The starter button can only be ope ...
© 2016-2024 Copyright www.vwgolf.org