Volkswagen Golf Service & Repair Manual: Removing and installing fresh air intake, LHD vehicles

Volkswagen Golf Service & Repair Manual / Heating, air conditioning / Air conditioner / Air duct / Removing and installing fresh air intake, LHD vehicles

Removing

–	Remove plenum chamber cover → General body repairs, exterior; Rep. gr.50.

–	Remove cover for fresh air intake → Chapter.

–	Remove air quality sensor -G238- (only on vehicles with Climatronic) → Chapter.

–	Remove nuts -arrows-.

–	Take the fresh air intake -1- out of the plenum chamber.

Installing

Install in reverse order.

Assembly sequence:

–	Align air intake grille on metal collar.

–	Hold air intake grille and screw on outer nut until it reaches half of welded stud.

–	Screw on nut on opposite side.

–	Tighten outer nut.

–	Tighten centre nut.

Note

The seal -2- must be properly seated on air intake grille.

Water may ingress into the fresh air intake if the fresh air intake grille is damaged or not properly fitted. This may result in complaints about odours from the heater and air conditioning system and/or about moisture in the vehicle.

Specified torques:

Removing and installing fresh air intake, LHD vehicles

Component	Specified torque
Nut	3 Nm

Assembly overview - air duct and air distribution in passenger compartment

Note The illustration shows a left-hand drive vehicle. 1 - Air duct for defroster vent ...

Removing and installing fresh air intake, RHD vehicles

Removing – Remove plenum chamber cover → General body repairs, exterior; Rep. gr.50. – ...

Other materials:

Overview of fitting locations - seat belts and anchorage points, estate
1 - Front belt buckles Assembly overview → Chapter Removing and installing → Chapter 2 - Front belt end anchor Assembly overview → Chapter Removing and installing → Chapte ...

Paint thickness tester -VAS 6197
Designation: Paint thickness tester -VAS 6197- Product description Fully electronic paint thickness tester with 2 independently functioning probes and liquid crystal display. Measurements are ...

Introduction
This chapter contains information on the following subjects: → Function When the toll card system is switched on and functioning, tolls will be charged automatically when driving through a toll booth. The charge will be confirmed by an acoustic signal. The charges will be relayed ...