Volkswagen Golf Service & Repair Manual: Removing and installing flywheel

Volkswagen Golf Service & Repair Manual / 4- cylinder injection engine(1.4 1 direct inction. turbocharger) / Enginecrankshaft group, pistons / Cylinder block, gearbox end / Removing and installing flywheel

Special tools and workshop equipment required

Counterhold -3067-

Removing

Gearbox removed

Removing and installing flywheel

–	Insert counterhold -3067- in hole on cylinder block -item B-.

–	Loosen and remove flywheel bolts.

Installing

Installation is carried out in the reverse order; note the following:

Note

Renew bolts that are tightened with specified tightening angle.

Flywheel with sender wheel can only be fitted in one position.

–	Insert counterhold -3067- in hole in cylinder block -item A-.

Specified torques

→ Chapter „Assembly overview - cylinder block, gearbox end“

Removing and installing flywheel

Assembly overview - cylinder block, gearbox end

Note For assembly work, secure engine to engine and gearbox support → Chapter. 1 - Bolt Renew 60 ...

Removing and installing sealing flange on gearbox side

Special tools and workshop equipment required Flared ring spanner tool insert AF 24 -V.A.G 1332/11 ...

Other materials:

Removing and installing Sanden belt pulley
Note The pulley is sensitive to impact and should therefore be treated with extreme care. If the belt pulley overload protection has deployed, check freedom of movement of air conditioner compressor before rene ...

Overview of fitting locations- sound system, vehicles with Dynaudio sound system
On vehicles equipped with a Dynaudio sound system, high-quality Dynaudio loudspeakers can be found at standard fitting locations. The Dynaudio sound system can be identified by the lettering Dynaudio on front treble loudspeaker trims. A subwoofer install ...

Assembly overview - fixed rear door window
1 - Fixed door window Removing and installing → Chapter 2 - Seal Part of window 3 - Bolt Qty. 2 6 Nm 4 - Cover Qty. 2 5 ...