|
– | Remove door trim → General body repairs, interior; Rep. gr.70. |
– | Remove window slot seal → Chapter. |
– | Remove window channel → Chapter. |
– | Lift out cover caps -6-. |
– | Remove bolts -5-. |
– | Pull seal -2- off metal flange. |
– | Guide release tool -T10236- one after the other under both clips -3-. |
– | When doing this, push door window -1- slightly outwards -arrow a- until clips -7- are pushed out of door -4-. |
– | Then pull door window -1- with web -7- upwards -arrow b- out of door -4-. |
|
– | Slide door window -1- into door -arrow a-. |
– | Push door window against door -5- until clips -6- engage audibly -arrows b-. |
– | Tighten bolts -4-. |
– | Pull seal -2- around flange. |
Specified torques |
Fixed rear door window → Chapter „Assembly overview |
Assembly overview - plenum chamber cover
1 -
Plenum chamber cover
q
Right side
q
Removing and installing
→ Chapter
2 -
Plenum chamber cover
Left side
Removing and installing
→ Chapter
3&nbs ...
Assembly overview - windscreen wiper system
Note
The illustration shows fitting locations for LHD vehicles. Fitting
locations for RHD vehicles are similar.
1 -
Wiper blade on driver side
Different lengths. Refer to
→ Electronic Parts Catalogue.
...
Removing and installing control unit 1 for information electronics -J794-
Special tools and workshop equipment
required
Radio release tool -T10057-
Protective cap for wiring harness connector -VAS 6223/ ...