Volkswagen Golf Service & Repair Manual: Removing and installing eyelet for net partition
| Special tools and workshop equipment
required |
|
|
|
| |
|
Removal wedge -3409- |
| Eyelet for net partition, without rear reading light |
 Note
| Removal and installation is described for the rear left
eyelet for net partition. Follow same instructions for the
remaining eyelets for net partition as appropriate. |
| – |
Release trim -1- with eyelet
for net partition at bottom from moulded headliner using removal
wedge -3409--arrow A-. |
| – |
Then, slightly guide trim -1-
with eyelet for net partition downwards out of moulded headliner
-arrow B-. |
| – |
After that, guide eyelet for net partition with trim upwards
out of moulded headliner, and remove it. |
Note
| On vehicles with sliding sunroof, the retaining lugs on
the rear trims -1- are reverted by
180°. The removal and installation procedure for these eyelets
for net partition must be adapted accordingly. |
|
|
|
| Eyelet for net partition, with rear reading light |
Note
| Removal and installation is described for the left eyelet
for net partition. Follow same instructions for the right eyelet
for net partition as appropriate. |
| – |
Remove rear left reading light -W11-
→ Electrical system; Rep. gr.96. |
| – |
Release retaining lugs -3- on
trim -1-, and release trim from
moulded headliner using removal wedge -3409--arrow
A-. |
| – |
Then, slightly guide trim -1-
with eyelet for net partition towards front out of moulded
headliner -arrow B-. |
|
|
|
| Install in reverse order, but note the following: |
Note
| Ensure that the locating lug -arrow-
on the bracket for net partition is properly seated in the
recess in the eyelet for net partition -1-. |
| |
→ Chapter „Assembly overview- net partition“ |
|
|
|
Removing
–
Remove luggage compartment side trim
→ Chapter.
–
Pull belt webbing aside, a ...
Note
Removal and installation is described for the sun visor
on driver side. Follow same instructions for the front passenger
side as appropriate.
...
Other materials:
Removing and installing drive shafts, triple roller joint AAR3300i bolted
Special tools and workshop equipment
required
Torque wrench -V.A.G 1332-
Press tool -T10520-
...
Permissible deviation in tread depth
Only tyres of the same construction and tread pattern should
be used on all four wheels.
Always fit the tyres with the deeper tread to the front
axle.
It is basically possible to replace tyres individually.
...
Causes of vibration
Vibration can have a number of different causes. Vibration
can also be caused by tyre wear. Tyre wear caused by driving is
not always evenly spread across the entire running surface of
the tyre. This causes slight imbalances which affect the smooth
runni ...
© 2016-2026 Copyright www.vwgolf.org
Removing and installing bracket for net partition
Removing and installing sun visor