Volkswagen Golf Service & Repair Manual: Removing and installing evaporator temperature sensor -G308-, RHD vehicles
Special tools and workshop equipment
required |
|
|
|
– |
Release evaporator temperature sensor -G308- using removal
wedge -3409-. |
– |
Pull evaporator temperature sensor -G308--2-
out of housing. |
– |
Disconnect electrical connector -1-. |
Install in reverse order. |
|
|
|
Special tools and workshop equipment
required
Removal wedge -3409-
Note
...
Checking
–
Remove right centre console trim in footwell
→ General body repairs, interior; Rep. gr.68.
...
Other materials:
Introduction
This chapter contains information on the following subjects:
→ General information on transporting children in the vehicle  
→ Various securing systems  
→ Using a child seat on the front passenger seat  
→ Using a child seat on the rear seats  
â ...
Assembly overview - alternator with sliding bushes
1 -
Alternator -C-
Removing and installing
→ Chapter
Checking
→ Chapter
Removing and installing poly V-belt pulley
→ Chapter
Removing and installing voltage reg ...
Removing and installing rear 3-point seat belt, 2-door model, with belt
tensioner
Removing
WARNING
Observe safety instructions for pyrotechnic
components
→ Chapter.
Observe disposal regulations for p ...
© 2016-2024 Copyright www.vwgolf.org