Volkswagen Golf Service & Repair Manual: Removing and installing ESP sensor unit -G419-

Volkswagen Golf Service & Repair Manual / Brake system / ABS, ADR, TCS, EDL, ESP / Sensors / Removing and installing ESP sensor unit -G419-

The lateral acceleration sender -G200-, the yaw rate sender -G202- and the longitudinal acceleration sender -G251- are installed together with the control unit for electromechanical parking brake -J540- in the ABS control unit -J104-.

The components cannot be renewed individually.

–	Removing and installing ABS control unit -J104- → Chapter.

Assembly overview - speed sensor on rear axle, all-wheel drive

1 - ABS speed sensor Clean inside surface of hole before inserting sensor Coat inside surface with high-temperature paste -G 052 112 A3- ...

Removing and installing speed sensors on front axle -G45-/-G47

Note Removal and installation is described for the front left speed sensor. Removal and installation of the front right speed sensor is analogous. ...

Other materials:

Overview of fitting locations – control units, front of LHD vehicles
1 - Data bus diagnostic interface -J533- Assembly overview → Chapter 2 - Bracket Assembly overview → Chapter 3 - Onboard supply control unit -J519- ...

Removing engine
Special tools and workshop equipment required Removal lever -80 - 200- Extension -2024 A /1- of lifting tackle -2024 A- Engine and gearbox jack -V.A.G 1383 A- or -VAS 6931- Engine bracket -T10497- Drip ...

Removing and installing heater and air conditioning unit
Special tools and workshop equipment required Torque wrench -V.A.G 1331/- (5…50 Nm) Hose clamps up to 25 mm -3094- ...