Volkswagen Golf Service & Repair Manual: Removing and installing engine speed sender -G28-
Special tools and workshop equipment
required |
|
|
|
– |
Remove noise insulation
→ General body repairs, exterior; Rep. gr.66. |
|
|
|
– |
Unscrew bolt -arrow- and push
charge air cooling pump -V188- to one side. |
|
|
|
– |
Disconnect electrical connector -1-. |
– |
Unscrew bolt -2- and remove
engine speed sender -G28-. |
Note
Carefully insert engine speed sender -G28- in bore! |
This will prevent the engine speed sender -G28- from falling
between engine and gearbox. |
– |
Install in reverse order. |
– |
Install noise insulation
→ General body repairs, exterior; Rep. gr.66. |
→ Chapter „Assembly overview - ignition system“ |
→ Chapter „Assembly overview - electric coolant pump“ |
|
|
|
Removing
–
Release hose clips -1- and
-2-, and remove air pipe.
...
Other materials:
Checking fuel delivery rate, vehicles with four-wheel drive
Special tools and workshop equipment required
Removal wedge -3409-
Remote control for V.A.G. 1348 -V.A.G 1348/3A-
Multimeter e.g. hand-held multimeter -V.A.G 1526E-
Test instrument adapter/DSO (5-pin) -VAS 5565-
...
Main beam assist
First read and observe the introductory information
and safety warnings Main beam assist (Light Assist)
Within the limits of the system, the main beam assist automatically switches
the main beam on at speeds of over approximately 60 km/h (37 mph), depending on
environmental and traffic con ...
2-pack clear coat
Designation:
2-pack clear coat -LLS MAX 210-
Issued 12.2010
Product description
The 2-pack clearcoat -LLS MAX 210- is a high-gloss
2-component clear coat for the permanent se ...
© 2016-2024 Copyright www.vwgolf.org