Volkswagen Golf Service & Repair Manual: Removing and installing engine sound generator control unit -J943-, vehicles
with active sound, Golf GTD
– |
Remove C-pillar trim
→ General body repairs, interior; Rep. gr.70. |
|
|
|
– |
Remove engine sound generator control unit -J943--1-
from side panel. |
– |
Release and disconnect electrical connector
-2-. |
Install in the reverse order of removal, observing the
following: |
→ Chapter „Overview of fitting locations – control units, rear“ |
|
|
|
Special tools and workshop equipment
required
Feeler gauge
Removing
–
If fitted, re ...
Repairs to wiring harnesses and
connectors
Note
All instructions and notes regarding this chapter are
available under
U ...
Other materials:
Introduction
This chapter contains information on the following subjects:
→ Stowing items of luggage
→ Driving with an open tailgate
→ Driving a loaded vehicle
→ Vehicle-specific weight ratings
Heavy objects must always be stowed securely in the luggage comp ...
General notes on brake fluid
Note
Only use new brake fluid conforming to VW standard (VW 501 14).
Brake fluid is poisonous. Also due to its corrosive effect
brake fluid must not come into contact with paintwork.
...
Indicator lamps
First read and observe the introductory information
and safety warnings
Lit up
Possible cause
Solution
The vehicle is being held by the electronic parking
brake.
Switch off the Auto Hold function if necessary .
...
© 2016-2024 Copyright www.vwgolf.org