Volkswagen Golf Service & Repair Manual: Removing and installing engine mountings

Volkswagen Golf Service & Repair Manual / 4- cylinder injection engine(1.4 1 direct inction. turbocharger) / Engine assy, cylinder blook, crankcase / Assembly mountings / Removing and installing engine mountings

Removing

–	Disconnect electrical connector -1-.

–	Move clear hose -2- from activated charcoal filter.

–	Using a screwdriver, release fasteners -arrow- and move coolant expansion tank to one side.

–	Supporting engine in installation position → Chapter „Supporting engine in installation position“

Removing and installing engine mountings

–	Unscrew bolts -arrows- and remove engine mounting -1-.

Installing

Installation is carried out in the reverse order; note the following:

–	Checking adjustment of assembly mountings → Chapter.

Specified torques

→ Chapter „Assembly overview - assembly mountings“

Removing and installing engine mountings

Supporting engine in installation position

Special tools and workshop equipment required Support bracket -10 - 222 A- ...

Removing and installing gearbox mounting

Removing – Release hose clips -1- and -2-, and remove air pipe. – ...

Other materials:

Removing and installing upper transverse link, front-wheel drive
Special tools and workshop equipment required Torque wrench -V.A.G 1332- Removing – Loosen wheel bolts. – ...

Run-flat tyres, seal inside technology
The vehicles are equipped with self-sealing tyres as an option. This technology, referred to as seal inside technology, is a system that has been developed to allow the car to continue to be driven even if a nail or screw has penet ...

Removing and installing front turn signal bulb -M5-/-M7- (gas discharge headlights)
Note Removal and installation are described for the left side. Removal and installation on the right side are carried out in the same way. If the left turn signal bulb on vehicles with TDI engine cannot be remo ...