VW Golf manuals

Volkswagen Golf Service & Repair Manual: Removing and installing electronically controlled damping control unit -J250-, saloon

Volkswagen Golf Service & Repair Manual / Running gear, axles, steering / Self- levelling air spring system / Electronically controlled damping system / Removing and installing electronically controlled damping control unit -J250-, saloon

Special tools and workshop equipment required
Vehicle diagnostic tester
Removing
Location: electronically controlled damping control unit -J250- is installed behind left luggage compartment side trim.
–  Disconnect battery → Electrical system; Rep. gr.27.
–  Pull out ignition key.
Vehicles with keyless entry and start system “Keyless Access”
–  Switch off ignition and open driver's door so that the steering lock engages.
Continuation for all vehicles
–  Remove left luggage compartment side trim → General body repairs, interior; Rep. gr.70.
   
–  Release release lever -1- in -direction of arrow-.
–  Pull off electrical connector -2-.
–  Press lugs -3- and -4- to rear.
–  Slide electronically controlled damping control unit -J250--5- downwards out of retainer -6-.
Installing
Install in reverse order of removal, observing the following:
–  Function Replace control unit must be performed with → Vehicle diagnostic tester if electronically controlled damping control unit -J250- has been renewed.
–  If the reference position has been re-adapted, the front camera for driver assist systems must be recalibrated on vehicles with lane departure warning function → Chapter „Calibrating front camera for driver assist systems“.
 

Removing and installing electronically controlled damping control unit -J250-, saloon

Assembly overview - electronically controlled damping system, multi-link suspension, saloon
1 -  Front right vehicle lever sender -G289- Removing and installing → Chapter 2 -  Front right body acceleration se ...

Removing and installing front body acceleration senders -G341-/-G342-
Special tools and workshop equipment required     Torque wrench -V.A.G 1410- Re ...

Other materials:

Removing and installing front tunnel cross-piece
Special tools and workshop equipment required         Torque wrench -V.A.G 1331- Removing –  If fitted, remove centre underbody panel →  ...

Checking systems with an expansion valve and reservoir (with internally regulated air conditioner compressor)
  Note Connecting air conditioner service station → Chapter. Observe the test prerequisites → Chapter. –  Raise engine speed to 2,000 rpm. ...

Assembly overview - brake servo/brake master cylinder, RHD vehicles
Complete brake master cylinders and brake servos can be renewed independently of each other. 1 -  Mounting bracket with brake pedal Assembly overview → Chapter. Removing and installing brake pedal → ...

© 2016-2024 Copyright www.vwgolf.org