Volkswagen Golf Service & Repair Manual: Removing and installing earth wire with battery monitor control unit -J367-,
vehicles without high-voltage system
| Special tools and workshop equipment
required |
|
|
|
| Torque wrench -V.A.G 1331- |
| – |
Removing battery -A-
→ Chapter. |
|
|
|
| – |
Unplug electrical connector -2-
at battery monitor control unit -J367--3-. |
|
|
|
| – |
Unscrew nut -1- from earth
cable -2-. |
| – |
Unscrew nut -3- and disconnect
earth cable together with battery monitor control unit -J367--4-. |
| Install in the reverse order of removal, observing the
following: |
| – |
Adapt battery monitor control unit -J367-
→ Chapter. |
| → Chapter „Assembly overview – battery, vehicles without
high-voltage system“ |
|
|
|
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331-
Removin ...
Special tools and workshop equipment
required
Torque wrench -V.A.G 1783-
Removin ...
Other materials:
Adjusting rear lid
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331-
Setting gauge -3371-
Note
Vehicle must be ...
Overview of fitting locations - parking brake
1 -
Hexagon socket head bolt
8 Nm
2 -
Parking brake motor
Left parking brake motor -V282-, fitting location: on rear left
brake caliper
Right parking brake motor -V283-, fitting location: on ...
Introduction
This chapter contains information on the following subjects:
→ Stowage compartment on the driver side
→ Stowage compartment in the roof console (glasses compartment)
→ Stowage compartment in the front centre console
→ Stowage compartment in the front ...
© 2016-2024 Copyright www.vwgolf.org
Removing and installing battery tray
Removing and installing earth wire with battery monitor control unit -J367-,
vehicles with high-voltage system