Volkswagen Golf Service & Repair Manual: Removing and installing driver side interior locking button for central locking system -E308-

Note

The removal and installation procedures are described for LHD vehicles. Removal and installation for RHD vehicles are similar.

Removing

–	Remove exterior mirror adjuster -EX11- → Chapter.

–	Release fasteners -arrows-.

–	Pull driver side interior locking button for central locking system -E308--1- out of trim for exterior mirror adjuster -EX11--2-.

Installing

Install in the reverse order of removal, observing the following:

–	Ensure that driver side interior locking button for central locking system -E308--1- engages audibly in trim for exterior mirror adjuster -EX11--2-.

–	Install exterior mirror adjuster -EX11--2- → Chapter.

–	Test functionality.

Removing and installing driver side interior locking button for central locking system -E308-

Note The removal and installation procedures are described for LHD vehicles. Removal and installation for RHD vehicles are similar. ...

Special tools and workshop equipment required Removal wedge -3409- Note ...

Checking charge air system for leaks
Special tools and workshop equipment required Charge air system tester -V.A.G 1687- Procedure – Relea ...

Removing and installing rear 3-point seat belt, estate, without belt tensioner
Removing – Remove bench seat → Chapter. – Remove rear seat backrest → Chapter. – Remove D-pillar trim → Chapter. ...

Removing and installing fresh air blower - V2-, RHD vehicles
Note If only the fresh air blower -V2- is defective, remove and install fresh air blower control unit -J126- → Chapter. Removing – Remove baffle plate → Chapter. ...