Volkswagen Golf Service & Repair Manual: Removing and installing drive shaft, right drive shaft, constant velocity
joints VL100 and VL107, e-Golf
Special tools and workshop equipment
required |
|
|
|
Torque wrench -V.A.G 1332- |
|
|
|
– |
Unbolt drive shaft from gearbox flange shaft
-arrows-. |
– |
Pull drive shaft out of wheel hub. |
If drive shaft cannot be pulled out of the wheel bearing by
hand, use press tool -T10520-. |
|
|
|
Before using press tool -T10520- ensure that thrust piece
-1- is inserted. |
Using press tool -T10520-: |
|
|
|
– |
To be able to press out drive shaft
-3-, secure press tool -T10520--1-
to wheel hub using 3 wheel bolts -2-. |
|
|
|
– |
It is essential to follow specified sequence. |
I - |
Tighten knurled nut -1-
hand-tight. |
II - |
Turn only bolt -2- using a
spanner in order to press out drive shaft with press tool
-T10520-. |
Note
At the end of the procedure or for pressing out drive shaft
further the spindle must be moved to its original position in
order to deploy the hydraulic force! |
|
|
|
– |
Remove drive shaft -1- from
wheel bearing, and swing it upwards in
-direction of arrow-. |
– |
Remove drive shaft -1-
downwards. |
Install in reverse order of removal, observing the
following: |
Before fitting the outer joint in the wheel hub, apply a
thin coat of assembly paste to the splines on the outer joint
→ Electronic Parts Catalogue “ETKA”. |
→ Chapter „Assembly overview - drive shaft“ |
→ Chapter „Loosening and tightening threaded connections of
drive shaft“ |
→ Chapter „Torque settings for wheel bolts“ |
Bolts for noise insulation
→ General body repairs, exterior; Rep. gr.66. |
|
|
|
Special tools and workshop equipment
required
Torque wrench -V.A.G 1332-
...
Special tools and workshop equipment required
Aluminium wedge -T10161-
Press tool -T10520-
Torque wrench -V.A.G 1332-
  ...
Other materials:
Assembly overview - sliding sunroof
1 -
Glass panel for panorama tilting sunroof (single pane safety glass)
Removing glass panel
→ Chapter
If drive defective, remove glass panel
→ Chapter
Adjusting glass panel
→ Chapter
2 -
Bolt
...
Assembly overview - roof spoiler
1 -
Roof spoiler
Material PC/PET
With foam strip serving as intermediate piece
With 4 fasteners with foam ring
Removing and installing
→ Chapter
2 -
Right side spoiler
With adhesive tape
Removing and installin ...
Removing and installing driver side footwell vents, RHD vehicles
Removing
Pyrotechnic components may trigger unintentionally.Risk of
injury.Discharge any static charge accumulated in your body by briefly
touching striker plate for door.
–
Remove driver side knee airbag
→ Genera ...
© 2016-2024 Copyright www.vwgolf.org