VW Golf manuals

Volkswagen Golf Service & Repair Manual: Removing and installing door lock

Special tools and workshop equipment required
   
   

Torque wrench -V.A.G 1331-
Torque wrench -V.A.G 1331-

  Note
  Removal and installation are described only for the left door lock. The right side is similar.
  The door window must be closed for subsequent work.
Removing
 

Socket -3410-
Socket -3410-

Removing and installing door lock

–  Remove front door trim → General body repairs, interior; Rep. gr.70.
–  Remove inner door cover → Chapter.
–  Remove door handle → Chapter.
–  If fitted, disconnect connector.
–  Remove bolts -2-.
–  Remove door lock -1- from door -arrow-.
  Note
Cables can be detached if this is necessary for subsequent work.
Detach cable from mounting bracket
–  Remove cover → Anchor
–  Turn cable -5- through 90° -arrow a- and take out of holder.
–  Swivel cable -arrow b- upwards until cable can be threaded out of eye in door lock -1--arrow c-.
Detach cable from interior door handle
–  Turn cable -4- by 90° and take it out of holding device.
–  Swivel cable -arrow d- so far until cable can be threaded out of eye in door lock -1--arrow e-.
Removing cover
   

Removing and installing door lock

–  Disengage hook -3- in -direction of arrow a-.
–  Use the hook to pull cover -1- out of door lock -2--arrow b-.
–  Pull cover -1- upwards -arrow c- from door lock -2-.

 
Installing
   

Removing and installing door lock

–  Attach cables -4- and -5- to door lock -1-.
–  Fit cover → Anchor.
–  Insert door lock -1- into door.
–  If fitted, connect connector.
–  Screw in bolts -2-.
–  Clip cover -3- in.
Further installation is performed in the reverse order of removal.
It is essential that a functional check is then performed with the door open. If the cables are not adjusted correctly and the door is closed without having performed a functional check, the door lock might not unlock and the door can't be opened.
Specified torques
  Bolts → Chapter „Assembly overview - door handle and door lock“
Fit cover

Removing and installing door lock

–  Push cover -1- onto retainer -3- on door lock -2--arrow a-.
–  Engage hook -4- with door lock -2--arrow b-.
Removing and installing mounting bracket
Special tools and workshop equipment required     Removing   Note Removal and installati ...

Removing and installing window channel
Removing and installing window channel   Note   The removal and installation sequence is only for the left window channel. Re ...

Other materials:

Removing and installing right temperature flap control motor -V159-, LHD vehicles
Special tools and workshop equipment required Vehicle diagnostic tester First carry out the following work: –  Switch off all electrical consumers. –  ...

Removing and installing brake pads, front brakes PC57 and C60
Special tools and workshop equipment required     Torque wrench -V.A.G 1331-   Piston resetting appliance -T 10145- ...

Contents
Fig. 217 Contents of the vehicle toolkit First read and observe the introductory information and safety warningsThe content of the vehicle toolkit depends on the vehicle equipment level. The following describes the maximum scope. The vehicle toolkit contains the following Screwdriver w ...

© 2016-2024 Copyright www.vwgolf.org