Volkswagen Golf Service & Repair Manual: Removing and installing door
| Special tools and workshop equipment
required |
- Door alignment tool -3320-
- Universal joint for 3320 -3320/1
- Bit for 3320 -3320/2-
- Bit for 3320 -3320/3-
- Torque wrench -V.A.G 1331-
- Socket -3410-
- Setting gauge -3371-
|
|
|
 Note
| The removal and installation sequence is for the front left
door. Removal and installation of the front right door are
similar. |
|
|
Removal wedge -3409- |
| – |
Press wedge -T10383/1- between bellows -3-
and locking mechanism -arrow a-. |
| – |
Push locking mechanism upwards -2- with
wedge -T10383/1--arrow b- and separate
electrical connector -3- from coupling
station -arrow c-. |
| – |
Undo screws -7- from hinges. |
| – |
Unscrew bolt -4- for door retaining
strap -5-. |
| – |
Push door arrester -6- inwards
-arrow d-. |
| – |
Lift front door -1- upwards
-arrow f- so that hinge
-6- is released from hinges
-7-. |
| Install in reverse order of removal. To this end, the following
should be observed: |
 Caution
| Prior to installing the front door, the door
retaining strap must be folded towards the inside of the vehicle
in order to avoid damage to the paintwork. |
|
Note
| After door installation the hinge arms must be flush one above the
other. |
| – |
Adjust front door -1-
→ Chapter. |
| – |
Observe front door shut lines -1-
→ Rep. gr.00. |
| Door arrester and hinges
→ Chapter „Assembly overview - door“ |
During production, a sealant is applied to the door inner
seals, which are then placed on the door flange and rolled on.
Note
When removing ...
Special tools and workshop equipment
required
Door alignment tool -3320-
Universal joint for 3320 -3320/1-
Bit for 3320 -3320/2-
Bit for 3320 - ...
© 2016-2024 Copyright www.vwgolf.org
Removing and installing door inner seal
Adjusting door