Volkswagen Golf Service & Repair Manual: Removing and installing dip beam screen motor -V294-/-V295

Volkswagen Golf Service & Repair Manual / Electrical system / Lights, lamps, switches outside / Headlight / Removing and installing dip beam screen motor -V294-/-V295

Note

Left dip beam screen motor -V294- and right dip beam screen motor -V295- are only fitted on gas discharge headlights without cornering light.

The dip beam screen motor is located in the headlight and cannot be renewed separately in the event of a fault.

–	Removing and installing headlights → Chapter.

Removing and installing LED modules for daytime running light and side light -L176-/-L177- (“GTE” only)

Special tools and workshop equipment required Torque wrench -V.A.G 1783- ...

Removing and installing bulbs for cornering light -L148-/-L149-

Note Left cornering light bulb -L148- and right cornering light bulb -L149- are only fitted on gas discharge headlights. R ...

Other materials:

Checking valve timing, engine codes CHPA, CMBA, CPVA, CXSA, CZCA, CPVB, CZDA
Special tools and workshop equipment required Torque wrench -VAS 6583- Locking pin -T10340- ...

Rear view
Fig. 3 Overview of the rear of the vehicle Key for : High-mounted brake light Rear window Rear window heating Rear wiper Tail light cluster Tailgate Rear sensors for the ParkPilot or Park Assist system Mounting for the rear to ...

Assembly overview - poly V-belt drive, vehicles without air conditioner compressor
1 - Bolt Renew 150 Nm +180° Use counterhold -T10475- to loosen and tighten. Risk of damage to engine caused by incorrect valve timing.Do not turn crankshaft out of TDC position. 2 - ...