Volkswagen Golf Service & Repair Manual: Removing and installing digital sound package control unit -J525
| Special tools and workshop equipment
required |
|
|
|
| Protective cap for wiring harness connector -VAS 6223/9- |
| If the control unit is replaced, select the
Replace function of the respective
control unit in Guided fault finding
→ Vehicle diagnostic tester. |
| – |
Switch off ignition and all electrical consumers, and remove
ignition key. |
| – |
Remove luggage compartment floor |
|
|
|
| – |
Release strap -1- and then
release and unplug connectors -2-
on digital sound package control unit -J525-. |
|
|
|
| – |
Push protective cap for cable connector -VAS 6223/9--1-
onto connector of MOST bus -2-. |
| – |
Remove digital sound package control unit -J525- |
| Install in the reverse order of removal. When doing this,
note the following: |
|
|
|
Special tools and workshop equipment
required
Torque wrench -V.A.G 1783-
...
Special tools and workshop equipment
required
Torque wrench -V.A.G 1783-
Removin ...
© 2016-2024 Copyright www.vwgolf.org
Digital sound package control unit -J525-, vehicles with Dynaudio
Removing and installing retainer for digital sound package control unit
-J525-