Volkswagen Golf Service & Repair Manual: Removing and installing daytime running light bulb -L174-/-L175-, gas
discharge headlights
Note
Removal and installation are described for the left side.
Removal and installation on the right side are carried out in
the same way. |
The left daytime running light bulb -L174- or right daytime
running light bulb -L175- also serves as the left side light
bulb -M1- or right side light bulb -M3-, respectively. |
|
|
|
– |
Turn housing cover -1- in
direction of arrow -A- and remove
it from headlight. |
|
|
|
– |
Pull grip of left daytime running light bulb -L174--1-
towards rear -arrow A- to remove
left daytime running light bulb from reflector. |
– |
Pull left daytime running light bulb -L174- out of grip. |
Install in the reverse order of removal, observing the
following: |
Caution
Risk of damage to the headlight. |
Do not touch the glass part of the bulb with bare
fingers. Fingers leave traces of grease on the glass
bulb, which vaporise when the bulb is switched on and
cause the glass bulb to cloud over. |
Wear, for example, clean fabric gloves when
inserting bulbs. |
Make sure the housing cover is correctly seated when
installing. The ingress of water will lead to permanent
damage to the headlight. |
|
– |
Check headlight setting and adjust headlight if necessary
→ Booklet36.1 |
|
|
|
WARNING
Risk of death due to high voltage! Risk of injury
and environmental pollution!
Ob ...
Note
Left LED module for daytime running light and side light
-L176- and right LED module for daytime running light and side
light -L177- are onl ...
Other materials:
Infrared heater -VAS 6874
Designation:
Infrared heater -VAS 6874-
Product description:
The infrared heater is used to dry putty, filler, base coat,
top coat and clear coat on vertical surfaces with 2 timers for
flashi ...
Removing and installing fuel rail
Removing
The fuel system is under high pressure.Risk of injury due to fuel which
may spurt out.Release high pressure.
→ Chapter
Risk of functional impairment due to soiling
→ Chapter.
...
Checking belt webbing
Procedure
–
Pull belt completely out of inertia reel or lap belt
adjustment plate.
–
Check belt webbing for soiling, and if necessary wash with a
mild soapy solution
→ Owner's ...
© 2016-2024 Copyright www.vwgolf.org