Volkswagen Golf Service & Repair Manual: Removing and installing data bus diagnostic interface -J533-

Volkswagen Golf Service & Repair Manual / Electrical system / Wiring / Control units / Removing and installing data bus diagnostic interface -J533-

Note

When renewing the control unit, select Renew function for the respective control unit in Guided fault finding or Guided functions mode → Vehicle diagnostic tester.

Removing

–	Unplug electrical connector -1- by reaching upwards behind pedal bracket.

–	Press locking detent to disconnect and pull off connectors.

–	Disengage catches -arrows-.

–	Pull data bus diagnostic interface -J533--3- downwards off bracket -2-.

Installing

Install in the reverse order of removal, observing the following:

Specified torques

→ Chapter „Assembly overview - data bus diagnostic interface“

Removing and installing data bus diagnostic interface -J533-

Removing and installing onboard supply control unit -J519-, RHD vehicles

Note When renewing the control unit, select Renew function for the respective control unit in Guided fault finding or Guided functions mode &# ...

Removing and installing bracket for onboard supply control unit -J519-, LHD vehicles

Removing – With ignition switched off, disconnect earth cable from battery → Chapter. – ...

Other materials:

Assembly overview - brake pedal, RHD vehicles
The brake pedal travel must not be restricted by additional floor coverings. Note Do not lubricate or grease the pivot pin. The pivot pin must remain dry. 1 - Bolt 20 Nm 2 - Mounting b ...

Removing and installing trim for operating and display unit
Removing – Starting at bottom, unclip trim for operating and display unit -1- from operating and display unit -2- and remove it. Installing Note Before installing, chec ...

Assembly overview - front vehicle level senders
Note The front left/right vehicle level sender -G78/G289- is only available as a replacement part complete with coupling rod and upper and lower retaining plates. 1 - Suspension link 2 - Subframe 3&nbs ...