Volkswagen Golf Service & Repair Manual: Removing and installing damper weight for refrigerant line, low-pressure
side
Special tools and workshop equipment
required |
|
|
|
Torque wrench -V.A.G 1331/- (5…50 Nm) |
– |
Observe safety precautions when working in the vicinity of
high-voltage components
→ Chapter „Safety precautions when working in the vicinity of
high-voltage components“. |
Note
It is not necessary to remove the refrigerant line in order
to remove and install the damper weight. |
Depending on the vehicle model, type of refrigerant lines
and production period, an additional damper weight
-2- may be installed on refrigerant
line -1-
→ Electronic Parts Catalogue. |
|
|
|
– |
Remove damper weight -2- from
refrigerant line on low-pressure-side -1-. |
– |
Fit damper weight -2- on
refrigerant line on low-pressure-side -1-.
Take specified dimension -a- = 30 ±
5 mm into account while doing so. |
Note
Ensure that the damper weight -2-
is firmly seated on the refrigerant line and that it won't make
contact with any other components during any condition. |
The refrigerant line on the low-pressure side
-1- must not be pinched due to the
additional weight -B-. |
|
|
|
Component |
Specified torque |
Bolts on damper
weight |
10 ± 1 Nm |
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331/- (5…50 Nm)
...
Special tools and workshop equipment
required
Torque wrench -V.A.G 1783
& ...
Other materials:
Removing and installing vibration damper
Special tools and workshop equipment
required
Counterhold -T10475-
Removing
–
Remove noise insulation
→ General body repairs, ...
Towing a trailer
Fig. 154 ParkPilot screen display when
towing a trailer (colour)
First read and observe the introductory information
and safety warnings Only the scanned area to the front of the vehicle is
shown on the infotainment system screen in vehicles with a factory-fitted towing
bracket and a tra ...
Checking inner constant velocity joint
The joint is to be dismantled to renew the grease if it is
heavily soiled, or to check the running surfaces of the balls
for wear and damage.
Note
The ball hub and joint body are paired. Mark position in
relation to each o ...
© 2016-2024 Copyright www.vwgolf.org