Volkswagen Golf Service & Repair Manual: Removing and installing cover frame for through-loading aperture
|
|
|
|
|
|
|
|
|
|
|
|
|
- Removing and installing lid for through-loading aperture
- Removing and installing centre armrest
- Removing and installing head restraint
- Removing and installing head restraint guide
- Removing and installing side padding
- Separating and connecting Bowden cable for remote release mechanism for seat backrest
- Removing and installing remote release operating mechanism for seat backrest
- Removing and installing Bowden cable for remote release mechanism for seat backrest
Removing and installing locking mechanism for rear seat backrest
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331
...
Removing and installing lid for through-loading aperture
Special tools and workshop equipment
required
Torque wrench -V.A.G 1410
...
Other materials:
Before operating the air conditioning system after recharging with
refrigerant
After installing a new air conditioner compressor or filling
with fresh refrigerant oil (e.g. after blowing out refrigerant
circuit), turn compressor pulley 10 revolutions by hand before
starting engine. This will prevent damage to the air conditioner
...
Assembly overview - speed sensor on rear axle, front-wheel drive
1 -
ABS speed sensor
Clean inside surface of hole before inserting sensor
Coat inside surface with high-temperature paste -G 052 112 A3-
Removing and installing
→ Chapter
2 -
Bolt
...
Repairing threaded connections
Special tools and workshop equipment
required
VAG 1331
Note
The use of penetrating fluid, contact spray or grease etc.
is prohibited since the missing ad ...
