Volkswagen Golf Service & Repair Manual: Removing and installing cover for parking lock

Volkswagen Golf Service & Repair Manual / 7- speed dual clutch gearbox 0CW / Gearbox. mechanics, gears, shafts, internal operation / Removing and installing cover for parking lock

Special tools and workshop equipment required

Removal lever -80 - 200-

Removing

Gearbox is installed.

Selector lever positioned in »P«.

Golf, Golf Estate, Golf SV, only diesel engine:

Remove air filter housing → Rep. gr.23.

Continued for all vehicles:

–	Remove battery and battery tray → Electrical system; Rep. gr.27.

Removing and installing cover for parking lock

–	Using removal lever -80 - 200-, lever selector lever cable -1- off gearbox selector lever.

Disregard bolts -2-.

Removing and installing cover for parking lock

–	Unscrew bolt -3- and detach gearbox selector lever -4-.

–	Unscrew bolts -2- and remove parking lock cover -1-.

Installing

Cover for parking lock must be renewed if seal for selector shaft or seal on cover for parking lock is leaking.

–	Clean sealing surface and cover for parking lock -1-.

–	Fit parking lock cover -1- and screw in bolts -2-.

–	Fit gearbox selector lever -4- and screw in bolt -3-.

Continue installation in reverse order of removal.

–	Install battery and battery tray → Electrical system; Rep. gr.27.

–	Adjust selector lever cable → Chapter.

Removing and installing cover for parking lock

Specified torque settings:

Removing and installing cover for parking lock

Gearbox. mechanics, gears, shafts, internal operation

...

Removing and installing parking lock

Removing Gearbox is installed. – Remove cover for parking lock -1- ...

Other materials:

Condenser
The condenser transfers heat from the compressed refrigerant gas to the surrounding air. This allows the refrigerant gas to condense into liquid form. ...

Removing broken front side window
Removal of a broken front side window is performed in the same manner as the removal of a broken rear window → Chapter. Removing and installing rear side window Note ...

Removing and installing manually operated anti-dazzle interior mirror, without rain and light sensor -G397- and front camera for driver assist systems -R242-
Removing – Turn interior mirror -2- anti-clockwise -arrow- by 90° (1/4 turn). – Remove interior mirror -2- from glued-on retaining plate -1-. Installing Note ...