Volkswagen Golf Service & Repair Manual: Removing and installing cover cap, without lock cylinder
 Note
|
|
|
| – | Remove plugs -3-. |
| – | Insert assembly tool -T10389- approx. 44 mm into the door behind locking hook -2- of the door handle bracket. |
| – | Pull assembly tool -T10389- approx. 5 mm backwards -arrow- until hook is detached. |
| – | Pull door handle -1- off door -arrow a-. |
| – | Pull cover cap -1- out of mounting bracket -arrow b-. |
|
| – | Pull door handle -2- off door in direction of -arrow a-. |
| – | Push cover cap -1- into mounting bracket -arrow b-. |
| – | Slightly press cover cap -1- onto door. |
| – | Insert flat-bladed screwdriver -4- approx. 40 mm into door handle bracket until locking hook -3- is reached. |
| – | Press cap -1- onto door. |
| – | Push screwdriver approx. 5 mm into hole -arrow- until hook locks in place -3-. |
| – | Insert plug -5-. |
Removing and installing cover cap, for lock cylinder
Removing and installing cover cap, for
lock cylinder
Note
When removing lock cylinder cover cap, the screwdriver should
not be turned a ...
Removing and installing lock cylinder
Removing and installing lock cylinder
Special tools and workshop equipment
required
N ...
Other materials:
Removing and installing Denso belt pulley
Note
The pulley is sensitive to impact and should therefore be
treated with extreme care.
If the belt pulley overload protection has deployed, check
freedom of movement of air conditioner compressor before
rene ...
Removing and installing infotainment system display
Special tools and workshop equipment
required
Removal wedge -3409-
Radio release tool -T10057-
Removing
...
Incorporation of heat exchanger for high-voltage battery into coolant circuit of
high-voltage system
Note
Fill coolant and bleed coolant circuit
→ Rep. gr.19.
The illustration below shows only some of the components of
the coolant circuit for the high-voltage system. For components
which are not sho ...
