Volkswagen Golf Service & Repair Manual: Removing and installing coolant temperature sender at radiator outlet -G83

Volkswagen Golf Service & Repair Manual / 4- cylinder injection engine(1.4 1 direct inction. turbocharger) / Engine cooling / Coolant pump, regulation of cooling system / Removing and installing coolant temperature sender at radiator outlet -G83

Removing

Engine cold

–	Briefly open cap of coolant expansion tank -arrow- in order to release residual pressure in the cooling system, then tighten the cap again until it engages.

–	Remove noise insulation → General body repairs, exterior; Rep. gr.66.

Removing and installing coolant temperature sender at radiator outlet -G83

–	Disconnect electrical connector -2-.

Note

Place a cloth underneath to catch escaping coolant.

–	Pull off retaining clip -1- and pull radiator outlet coolant temperature sender -G83- out of connection -3-.

Installing

Installation is carried out in the reverse order; note the following:

Note

Renew O-ring.

Insert new coolant temperature sender -G62- immediately into connection in order to avoid loss of coolant.

–	Install front noise insulation → General body repairs, exterior; Rep. gr.66.

–	Check coolant level → Anchor.

Removing and installing coolant temperature sender at radiator outlet -G83

Removing and installing coolant temperature sender -G62

Removing Engine cold – Briefly open cap of coolant expansion tank - ...

Coolant pipes

...

Other materials:

Removing and installing refrigerant shut-off valve for high-voltage battery heat exchanger -N542
Removing – Observe safety precautions → Chapter „Safety precautions when handling refrigerants“. – Comply with notes → Chapter „Working on refrigerant circuit“. ...

Checking adjustment of assembly mountings (engine and gearbox mountings)
Procedure The following specifications must be obtained: There must be a distance of -a- = 10 mm between engine support -2- and engine mounting -1-. ...

Matting additive -LVM 769 810 A2
Designation: Matting additive -LVM 769 810 A2- Issued 10.2014 Product description The matting additive -LVM 769 810 A2- is an additive for 2-pack HS clear coats and 2-pack HS ...