Volkswagen Golf Service & Repair Manual: Removing and installing control unit for fuel tank leak detection -J909-
– |
Release and pull off connector -arrow-
on control unit for fuel tank leak detection -J909--1-. |
|
|
|
– |
Push control unit for fuel tank leak detection -J909--1-
on both sides evenly upwards -arrows-,
until the catch can be heard to disengage. |
– |
Remove control unit for fuel tank leak detection -J909--1-
from bracket -2-. |
Install in reverse order. In the process, note the
following: |
|
|
|
– |
Fit control unit for fuel tank leak detection -J909--1-
properly in mounting -2-. |
– |
Pull control unit for fuel tank leak detection -J909- evenly
downwards until it can be heard to engage. |
|
|
|
Removing
Note
The tank pressure sensor -G400- is located in the pressure
regulating valve on the activated charcoal filter
→ ...
Separating plug-in connectors
Special tools and workshop equipment
required
Lever -T10468-
...
Other materials:
Removing and installing turn signal switch -E2-, Kostal
Note
The turn signal switch -E2-, cruise control system switch
-E45- and intermittent wiper switch -E22- are combined to form
the steering column combination switch -E595-.
These switches cannot be separated.
...
Adjusting glass panel
Special tools and workshop equipment
required
Height-adjustment of glass panel
Torque wrench -V.A.G 1783-
–
Loosen securing bolts for ...
Assembly overview - Bowden cable
1 -
Release lever
Removing and installing
→ Chapter
2 -
Bolt
Qty. 2
1.5 Nm
3 -
Mounting bracket
4 -
Expanding nut
Qty. 2
5 - ...
© 2016-2024 Copyright www.vwgolf.org