Volkswagen Golf Service & Repair Manual: Removing and installing control unit for electronic steering column lock
-J764-
Note
When renewing control unit, select
Renewal function for respective control unit in “Guided
fault finding” or “Guided functions” using → Vehicle
diagnostic tester. |
Special tools and workshop equipment
required |
|
|
|
– |
Remove steering column switch module
→ Electrical system; Rep. gr.94. |
|
|
|
– |
Disconnect connector -2-. To do
this, slide catch -1- to rear and
push release downwards. |
– |
Unscrew shear-head bolt -3-
using socket -T10424-. |
– |
Remove control unit for electronic steering column lock
-J764--item 4- |
Note
If the shear-head bolt cannot be removed using socket
-T10424-, drill out using an angle drill and an 8.5 mm twist
drill. |
Install in reverse order of removal, observing the
following: |
|
|
|
– |
Tighten new bolts -arrow- until
shear-head shears off. |
|
|
|
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331-
...
Other materials:
2-pack steel filler set
Designation:
2-pack steel filler set -DA 787 300 A2-
Issue 09.2012
Product description
This filler is a polyester filler with a powdered metal
mixture for the creation ...
City emergency brake function
Fig. 175 The display in the instrument
cluster: advance warning display
First read and observe the introductory information
and safety warnings The city emergency brake function is part of the area
monitoring system (Front Assist) and is active when Front Assist is switched on.
Dependin ...
Saw-tooth wear
Saw-tooth wear is a stepped wear pattern on the individual
tread blocks → Fig.
that can cause increased tyre noise. The saw tooth is caused by
uneven deformation of the tread blocks in the tyre's contact
patch. Saw-tooth wear is more pronounce ...
© 2016-2024 Copyright www.vwgolf.org