Volkswagen Golf Service & Repair Manual: Removing and installing connecting Bowden cable
| – |
Remove backrest cover and backrest padding
→ Chapter. |
|
|
|
| – |
Swing mounting bracket for backrest release mechanism
-1- upwards as far as stop
-arrow- and hold it in this
position. |
| – |
Detach connecting Bowden cable -3-
from mounting bracket. |
| – |
Swing operating lever -2-
upwards as far as stop. |
| – |
Detach connecting Bowden cable from operating lever and
remove it. |
| Installation is carried out in reverse order. |
| |
→ Chapter „Assembly overview - front backrest“ |
| |
→ Chapter „Assembly overview - front seat“ |
|
|
|
Removing
–
Remove backrest cover and backrest padding
→ Chapter.
...
Special tools and workshop equipment
required
Special pop rivet pliers -V.A.G 1753B-
...
Other materials:
Closing sunroof by hand
Removing
–
Remove glass panel
→ Chapter.
–
If drive is defective, remove glass panel
→ Chapter.
–
Pull self-adhesive insulation -3- off.
–
Remove bolts -2-.
...
The dangers of assuming an incorrect sitting position
First read and observe the introductory information
and safety warnings If the seat belts are not worn or are worn incorrectly,
the risk of severe or fatal injuries increases. Seat belts can only provide optimal
protection if the seat belt routing is correct. Assuming an incorrect sitting po ...
Assembly overview – special add-on parts, “R”
1 -
Front bumper cover
“R”
→ Chapter
2 -
Emblems on radiator grille
“R”
→ Chapter
3 -
Rear lettering
“R”
→ Chapter
4 -
R ...
© 2016-2024 Copyright www.vwgolf.org
Removing and installing backrest release mechanism
Removing and installing mounting bracket for backrest release mechanism