Volkswagen Golf Service & Repair Manual: Removing and installing charge pressure sender -GX26-

Volkswagen Golf Service & Repair Manual / 4- cylinder injection engine(1.4 1 direct inction. turbocharger) / Exhaust turbocharger, g-charger / Charge air system / Removing and installing charge pressure sender -GX26-

Charge pressure sender -GX26- consists of

Charge air pressure sender -G31-

Intake air temperature sender -G42-

Removing

–	Disconnect electrical connector -1-.

–	Release fasteners -arrows-, and remove charge pressure sender -GX26-.

Installing

Installation is carried out in the reverse order; note the following:

Note

Renew O-ring.

If the retaining tabs broke off during removal, the sender can be secured using two securing bolts as per → Electronic Parts Catalogue. Specified torque: → Anchor

Torque

Removing and installing charge pressure sender -GX26-

Component	Specified torque
Charge air pressure sender -GX26-	3 Nm

Assembly overview - charge air system

Note Check all air hoses and pipes for firm seating and leaks before carrying out tests or repairs. Observe rules for cleanliness → Chapter. ...

Removing and installing charge air cooler

Special tools and workshop equipment required Hose clamps up to 25 mm -3094- ...

Other materials:

Overview of fitting locations - components not located in passenger compartment, Golf and Golf GTE, RHD vehicles
1 - Exhaust ventilation for passenger compartment Checking → Chapter Removing and installing → Chapter. 2 - Humidity sender for air conditioning system -G260- Check ...

Assembly overview - Bowden cable
1 - Release lever Removing and installing → Chapter 2 - Bolt Qty. 2 1.5 Nm 3 - Mounting bracket 4 - Expanding nut Qty. 2 5 - ...

Assembly overview - emission control
1 - Bolt 20 Nm 2 - Bracket Renew if damaged 3 - Nut Specified torque and tightening sequence → Fig. 4 - Bolt ...