Volkswagen Golf Service & Repair Manual: Removing and installing charge pressure positioner -V465-
– |
Disconnect electrical connector -1-. |
– |
Remove securing clip -2-. |
– |
Remove bolts -arrows- and
detach charge pressure positioner -V465-. |
Installation is carried out in the reverse order. When
installing, note the following: |
Renew securing bolts and retaining clips. |
Note
There may be different types of charge air pressure
controllers installed. |
Charge air pressure controller without adjustable linkage |
– |
Adapt engine control unit -J623- to charge air pressure
controller -V465- using → Vehicle
diagnostic tester. |
Charge air pressure controller with adjustable linkage |
– |
Fit thread of charge pressure positioner -V465- at central
position in joint element. |
– |
Adjust charge air pressure controller -V465-:
→ Vehicle
diagnostic tester Select 01 -
Adjust charge air pressure controller V465 in
Guided functions. |
– |
Adjust to specified value by turning linkage. For specified
value, see → Vehicle
diagnostic tester. |
– |
Tighten lock nut to 6 Nm and secure with sealing paint. |
→ Chapter „Assembly overview - turbocharger“ |
|
|
|
Special tools and workshop equipment
required
Engine bung set -VAS 6122-
...
Other materials:
Notes on tow-starting
First read and observe the introductory information
and safety warningsVehicles should not be tow-started wherever possible.
Use jump leads to start the engine instead .
For technical reasons, the following vehicles cannot be tow-started:
Vehicles with an automatic gearbox.
Vehicle ...
Checking
Switch off ignition.
–
Connect manifold gauge (air conditioner service station).
–
Read pressure gauge. It may display two results, A and B.
Ambie ...
Pressing tyre off wheel rim
New wheels with a modified contour have been introduced for
all vehicles as of model year 2005.
The tyre fitting unit must be furnished with the tyre
fitting head designed for these wheels.
WA ...
© 2016-2024 Copyright www.vwgolf.org