Volkswagen Golf Service & Repair Manual: Removing and installing charge air cooling pump -V188-

Volkswagen Golf Service & Repair Manual / 4- cylinder injection engine(1.4 1 direct inction. turbocharger) / Engine cooling / Coolant pump, regulation of cooling system / Removing and installing charge air cooling pump -V188-

Special tools and workshop equipment required

Hose clamps up to 25 mm -3094-

Removing and installing charge air cooling pump -V188-

Drip tray for workshop hoist -VAS 6208-

Removing and installing charge air cooling pump -V188-

Hose clip pliers -VAS 6362-

Removing

Removing and installing charge air cooling pump -V188-

–	Open cap -arrow- on coolant expansion tank.

The cooling system is under pressure when the engine is hot. Hot steam/hot coolant can escape - risk of scalding. Risk of scalding to skin and body parts.Wear protective gloves.Wear eye protection.Release pressure by covering cap of coolant expansion tank with a cloth and opening it carefully.

–	Remove noise insulation → General body repairs, exterior; Rep. gr.66.

Removing and installing charge air cooling pump -V188-

–	Disconnect electrical connector -1-.

–	Set drip tray for workshop hoist -VAS 6208- underneath.

–	Clamp off coolant hoses on charge air cooling pump -V188- using hose clamps up to 25 mm -3094-.

–	Release hose clips -3- and detach coolant hoses.

–	Unscrew bolt -2- and remove charge air cooling pump -V188-.

Installing

Installation is carried out in the reverse order; note the following:

Note

Secure all hose connections with the same type of hose clips as original equipment → Electronic Parts Catalogue.

–	Install noise insulation → General body repairs, exterior; Rep. gr.66.

–	Check coolant level → Anchor.

Specified torques

→ Chapter „Assembly overview - electric coolant pump“

Removing and installing charge air cooling pump -V188-

Removing and installing thermostat for small cooling circuit

Removing – Remove coolant pump → Chapter. – Rem ...

Removing and installing coolant temperature sender -G62

Removing Engine cold – Briefly open cap of coolant expansion tank - ...

Other materials:

Undercoating, additional protected areas on hybrid vehicles
Undercoating, rear body of hybrid vehicles a - Undercoating Coat thickness: 0.3 mm b - Undercoating Coat thickness: 0.5 mm ...

General information
The drive is provided by the test rig. For vehicles with a manual gearbox, ensure that the gear lever is in neutral for the test. For vehicles with an automatic gearbox, ensure that the selector lever is in »N«. ...

Removing and installing fuel pressure sender -G247-
Special tools and workshop equipment required Assembly tool -T10118- Socket, 27 mm -T40218- or commercially available 27 mm ...