Note
The removal and installation procedures may have to be modified slightly depending on engine fitted. |
Removing |
Unclip spreader river -2- and remove centre underbody panels. |
Installing |
Installation is carried out in reverse order. |
Removing and installing headlight dipped beam bulb (LED)
Special tools and workshop equipment
required
Front-end hook -3370-
Torque wrench -V.A.G 1783-
...
Removing and installing tail light
Note
Removal and installation are described for the left side.
Removal and installation on the right side are carried out in
the same way.
If the event of a defective LED, the entire tail light needs
to be rene ...
Assembly overview - axle beam
1 -
Cover
2 -
Bolt
Renew after removing
50 Nm +45°
3 -
Bolt
Renew after removing
Tighten in unladen state
→ Chapter.
...