VW Golf manuals

Volkswagen Golf Service & Repair Manual: Removing and installing centre underbody cover – e-Golf

Volkswagen Golf Service & Repair Manual / General body repairs, exterior / Exterior equipment / Noise insulation / Removing and installing centre underbody cover – e-Golf

Removing and installing centre underbody cover – e-Golf

Removing
–  Remove bolts -2-.
–  Unscrew nuts -3-.
–  Remove underbody cover -1-.
Installing
Install analogously in reverse order, but note the following:
Specified torque
  Bolts → Item
  Nuts → Item
Removing and installing short centre underbody cover
  Note The removal and installation procedures may have to be modified slightly depending on engine fitted. Removing Unclip spreader river -2- and r ...

Removing and installing rear underbody cover – petrol/diesel
  Note The removal and installation procedures may have to be modified slightly depending on engine fitted. –  Loosen lock washer -3-. †...

Other materials:

Vehicles with multilink suspension
Removing –  If fitted, remove rear left underbody trim → General body repairs, exterior; Rep. gr.66. –  Remove rear tunnel cross-piece → General body repairs, exterior; ...

Removing and installing roof aerial -RX5-
Special tools and workshop equipment required     Torque wrench -V.A.G 1783-   Note Aerial wirings are directly plugged at the base of roof aerial -RX5-. ...

Dimensions
Fig. 21 Dimensions First read and observe the introductory information and safety warnings The data in the table apply to the most basic German model. The specified values can vary due to different tyre and wheel sizes, if additional equipment is fitted, for different model versions, for ...

© 2016-2024 Copyright www.vwgolf.org