Volkswagen Golf Service & Repair Manual: Removing and installing centre console trim in footwell

Volkswagen Golf Service & Repair Manual / General body repairs, interior / Interion equipment / Centre console / Removing and installing centre console trim in footwell

Note

Removal and installation is described for the centre console trim in footwell on driver side. Follow same instructions for the front passenger side as appropriate.

Special tools and workshop equipment required

Removing

Torque wrench -V.A.G 1783-

–	Remove bolt -3-.

–	Pull centre console trim in footwell -1- downwards out of mountings in centre console -2- and remove it.

Removing and installing centre console trim in footwell

Installing

Note

Before installing, check all fasteners for damage and renew if necessary.

Installation is carried out in reverse order.

Specified torques

→ Chapter „Assembly overview - centre console“

Removing and installing rear centre console trim

Special tools and workshop equipment required Removing – Move front seat ...

Removing and installing trim for operating and display unit

Removing – Starting at bottom, unclip trim for operating and display unit -1- from operating and display unit -2- and remove it. ...

Other materials:

Dealing with problems with Midtronics -MCR340V- battery tester
Under certain circumstances, the display may show errors or messages according to status. The most frequent display messages are listed below, together with suggested solutions. Note For messages not liste ...

Removing and installing dash panel insert trim
Special tools and workshop equipment required Removal wedge -3409- Removing – Release locking lever of steering wheel pos ...

Overview of fitting locations - aerial systems
1 - Frequency modulation (FM) frequency filter in positive wire -R179- On window frame to the left of the rear lid FM trap circuit (+) Has the task of preventing the aerial signals being shorted to earth R ...