Volkswagen Golf Service & Repair Manual: Removing and installing centre console retainer, securing bracket and insulation for selector mechanism, e-Golf only

Volkswagen Golf Service & Repair Manual / General body repairs, interior / Interion equipment / Centre console / Removing and installing centre console retainer, securing bracket and insulation for selector mechanism, e-Golf only

Special tools and workshop equipment required

Torque wrench -V.A.G 1783-

Removing

Front bracket

Note

Removal and installation is described for the front bracket on the driver side. Follow same instructions for the front passenger side as appropriate.

–	Remove centre console trim in footwell on driver side → Chapter.

Torque wrench -V.A.G 1783

–	Push floor covering in area of front bracket -2- aside.

–	Release cover -1- from front bracket -2- and remove it.

–	Remove front bracket -2- upwards from tunnel -3-.

Securing bracket and insulation for selector mechanism

–	Remove centre console → Chapter.

Torque wrench -V.A.G 1783

–	Remove bolt -1-.

–	Remove securing bracket -2- upwards from selector mechanism insulation -3-.

–	Remove air duct vent at rear of centre console → Heating, air conditioning; Rep. gr.87.

Torque wrench -V.A.G 1783

–	Remove 4 nuts -1-.

–	Remove selector mechanism insulation -2-.

Installing

Note

Before installing, check all fasteners for damage and renew if necessary.

Installation is carried out in reverse order.

Specified torques

→ Chapter „Assembly overview - centre console, e-Golf“

Torque wrench -V.A.G 1783

Removing and installing centre console retainer, for all vehicles except e-Golf

Special tools and workshop equipment required Removing Front bracket ...

Front centre armrest

Assembly overview - front centre armrest 1 - Front centre armrest Removing and installing → Chapter Removing and installing front centre armrest ...

Other materials:

Statutes and regulations
Note The laws and regulations listed below are valid in the Federal Republic of Germany. Other or additional laws and regulations may apply in other countries. Sources in other countries may be obtained from the ...

Removing and installing front air distribution flap control motor -V426-, RHD vehicles
Special tools and workshop equipment required Vehicle diagnostic tester First carry out the following work: – Switch off all electrical consumers. – ...

Removing and installing tyre pressure sensor, tyre pressure sensor with valve
Removing – Unscrew union nut -1-. – Remove tyre pressure sensor-2- from bed of wheel rim. Installing ...