Volkswagen Golf Service & Repair Manual: Removing and installing centre console retainer, for all vehicles except
e-Golf
| Special tools and workshop equipment
required |
|
|
|
 Note
| Removal and installation is described for the front bracket
on the driver side. Follow same instructions for the front
passenger side as appropriate. |
| – |
Remove centre console trim in footwell on driver side
→ Chapter. |
|
|
|
| – |
Push floor covering in area of front bracket
-2- aside. |
| – |
Release cover -1- from front
bracket -2- and remove it. |
| – |
Remove front bracket -2-
upwards from tunnel -3-. |
|
|
|
| – |
Remove centre console
→ Chapter. |
| – |
Remove bolt -1- on left and
right. |
| – |
Remove securing bracket -2-
upwards from selector mechanism insulation
-3-. |
|
|
|
| Bracket in front of selector mechanism |
Note
| Removal and installation is described for the bracket in
front of selector mechanism on driver side. Follow same
instructions for the front passenger side as appropriate. |
| – |
Remove centre console
→ Chapter. |
| – |
Remove retainer -1- from
selector mechanism insulation -2-. |
|
|
|
| Bracket behind selector mechanism |
| – |
Remove centre console
→ Chapter. |
| – |
Push retaining lugs -2-
outwards. |
| – |
Remove retainer -1- from
selector mechanism insulation -3-. |
Note
| Before installing, check all fasteners for damage and renew
if necessary. |
| Installation is carried out in reverse order. |
|
|
|
| Bracket in front of selector mechanism |
| Insert retainer in front of selector mechanism
-1- into the rear mountings of
selector mechanism insulation -2-. |
| |
→ Chapter „Assembly overview - centre console“ |
|
|
|
Special tools and workshop equipment
required
Removal wedge -3409
...
Special tools and workshop equipment
required
Torque wrench -V.A.G 1783-
...
Other materials:
Removing and installing underbody heat shield
Note
The removal and installation procedures may have to be modified
slightly depending on engine fitted.
Removing
–
Removing centre underbody panel
→ Chapter.
–
Removing front tunnel cross-piec ...
Removing and installing front trim for sliding sunroof
Special tools and workshop equipment
required
Cartridge gun -V.A.G 1628-
Electric cutter -V.A.G 1561A-
...
Warning lamp
Fig. 57 Warning lamp in the instrument
cluster
Fig. 58 Seat belt status for the rear seats
in the instrument cluster
First read and observe the introductory information
and safety warnings
Lights up or flashes
Possible cause
Solution
...
© 2016-2024 Copyright www.vwgolf.org
Removing and installing mounting plate with retaining strap
Removing and installing centre console retainer, securing bracket and
insulation for selector mechanism, e-Golf only