Volkswagen Golf Service & Repair Manual: Removing and installing centre console front storage compartment

Volkswagen Golf Service & Repair Manual / General body repairs, interior / Interion equipment / Centre console / Removing and installing centre console front storage compartment

Removing

–	Remove trim for operating and display unit → Chapter.

–	Unclip front storage compartment -1- from centre console -2--arrows A-.

–	Remove front storage compartment -1- towards rear from centre console -2--arrow B-.

–	If fitted, disconnect connectors on storage compartment.

Installing

Note

Before installing, check all fasteners for damage and renew if necessary.

Ensure that the locating lug on the front storage compartment is properly seated in the hole of the centre console.

Installation is carried out in reverse order.

Note

When installing, fit storage compartment at an angle, and insert it in guide at rear. Then, push storage compartment downwards, and engage it.

Removing and installing centre console front storage compartment

Removing and installing trim for operating and display unit

Removing – Starting at bottom, unclip trim for operating and display unit -1- from operating and display unit -2- and remove it. ...

Removing and installing centre console cover

Note Removal and installation is described for the centre console cover on driver side. Follow same instructions for the front passenger side as approp ...

Other materials:

Turn signal and main beam lever
Fig. 81 Turn signal and main beam lever First read and observe the introductory information and safety warnings Move the lever into the required position: Right turn signal . With ignition switched off move from central position for right parking light . Left turn signal � ...

Assembly overview - rear vehicle level senders, multi-link suspension, four-wheel drive
Note The vehicle level sender is available as a replacement part only complete with coupling rod and upper and lower retaining plates. 1 - Pop rivet nut 2 - Electrical connector 3 - Pop rivet ...

Overview of fitting locations - operating and display unit, Climatronic
Note A warning lamp in the instrument panel controls will indicate that the selected function is active. In addition, the display of the radio or of the radio navigation system will indicate the selected function for a short time when a bu ...