VW Golf manuals

Volkswagen Golf Service & Repair Manual: Removing and installing camshaft adjuster

Special tools for removing and installing the camshaft adjuster of exhaust camshaft
Special tools and workshop equipment required
   
Support bracket -10 - 222 A-
Shackle -10 - 222 A /12-
Adapter -10 - 222 A /18-
Adapter -10 - 222 A /29-
Adapter -T40091/1-
Adapter -T40091/3-
Adapter -T40093/3-
Adapter -T40093/3-6-
Removing
Camshaft adjuster for exhaust camshaft
  Note
For removing the camshaft adjuster of the exhaust camshaft, you only need to detach the engine support and the lower toothed belt guard.
The bolts must be unscrewed far enough to enable this.
Then, the top part of engine support is swung away from the engine.
–  Detach engine support → Chapter.
–  Detach toothed belt from camshafts → Chapter.
Camshaft adjuster for inlet camshaft
–  Detach toothed belt from camshafts → Chapter.
Installing
Installation is carried out in the reverse order; note the following:
  Note
Before installing the camshaft adjuster, ensure that the guide sleeve is inserted in the camshaft.
Specified torques
→ Chapter „Assembly overview - assembly mountings“
→ Chapter „Assembly overview - poly V-belt drive“
→ Chapter „Assembly overview - toothed belt cover“
→ Chapter „Assembly overview - coolant pipes“
→ Electrical system; Rep. gr.27
Check adjustment of assembly mountings (engine and gearbox mountings) → Chapter
 

Removing and installing camshaft adjuster

Removing and installing camshaft control valve 1 -N205- and exhaust camshaft control valve 1 -N318-
  Note On engines with codes CMBA, CPVA, CXSA, CZCA and CPVB, only camshaft control valve 1 -N205- is installed. Removing ...

Measuring axial play of camshaft
Special tools and workshop equipment required     Universal dial gauge bracket -VW 387- &nb ...

Other materials:

Assembly overview - Bowden cable
1 -  Release lever Removing and installing → Chapter 2 -  Bolt Qty. 2 1.5 Nm 3 -  Mounting bracket 4 -  Expanding nut Qty. 2 5 -  ...

Removing and installing left temperature flap control motor -V158-, LHD vehicles
Special tools and workshop equipment required Vehicle diagnostic tester First carry out the following work: –  Switch off all electrical consumers. –  ...

Balancing wheel, balancing wheel on stationary wheel balancer
Road test has been carried out → Chapter. Clamp wheel into wheel balancing machine   Note When balancing tyres, please remember that cleanliness is absolutely essential, as is the case in an ...

© 2016-2024 Copyright www.vwgolf.org