Volkswagen Golf Service & Repair Manual: Removing and installing brake pedal

Volkswagen Golf Service & Repair Manual / Brake system / Brake, brake mechanics / Brake pedal / Removing and installing brake pedal

It is not possible to remove the brake pedal separately.

–	To be able to remove it, pedal cluster/mounting bracket needs to be removed first → Chapter.

Note

Removing brake pedal with mounting bracket removed

–	Turn pivot pin clockwise in direction indicated by -arrow-.

-1- = 14 mm hex socket wrench

Note

This action will break off the tabs -B-. Renew the pivot pin.

–	Remove securing clip from pivot pin.

–	Pull out pivot pin towards right.

–	Remove brake pedal from mounting bracket.

Installing

Install in reverse order of removal, observing the following:

Note

Renew pivot pin and securing clip.

Note

Do not lubricate or grease the pivot pin. The pivot pin must remain dry.

–	Slide pivot pin from right to left through mounting bracket and brake pedal.

–	Fit securing clip to pivot pin when pivot pin has been inserted into both holes in mounting bracket.

Removing and installing brake pedal

–	Turn pivot pin anti-clockwise in direction indicated by -arrow- until tabs -A- engage audibly on stop in mounting bracket.

–	Install pedal cluster/mounting bracket → Chapter.

Removing and installing brake pedal

Connecting brake pedal to brake servo

Hold ball head of plunger rod in front of mounting and push brake pedal in direction of brake servo, so that the ball head clicks into place. ...

Brakes, hydraulics, regulator, servo

...

Other materials:

Removing and installing head restraint guide
Note 2 commercially available screwdrivers with a blade height of 0.4 mm and a blade width of 8 mm are required for removal. Removing – Remove rear ...

Assembly overview - D-pillar trim
Note The illustration shows the D-pillar trim on the left side. The right-hand side is similar (mirror image of left-hand side). 1 - D-pillar trim Removing and installing → Chapter 2 - Retaining cli ...

Dismantling and assembling heater unit
It is not necessary to extract the refrigerant and to remove or disassemble the expansion valve and the evaporator. Further procedure is identical with procedure for vehicles with air conditioning system → Chapter. ...