Volkswagen Golf Service & Repair Manual: Removing and installing brake light switch, LHD vehicles
Vehicles with diesel engine: |
– |
Remove air hose from air filter housing. |
|
|
|
– |
Open clamp -2- and screw-type
clip -3-. |
– |
Remove air ducting hose -1-. |
|
|
|
Continuation for all models: |
– |
Disconnect connector -2- from
brake light switch -F--1-. |
– |
Pull brake light switch -F--1-
at bottom off brake master cylinder. |
Install in reverse order of removal, observing the
following: |
|
|
|
– |
Ensure that brake light switch -F--1-
seats properly on edge -arrow- of
brake master cylinder. |
→ Chapter „Assembly overview - brake servo/brake master
cylinder, LHD vehicles“ |
|
|
|
Note
Only use new brake fluid conforming to VW standard (VW 501 14).
1 -
Cap
...
Removing
Vehicle with diesel engine:
–
Remove engine cover panel
→ ...
Other materials:
Removing dual clutch
Special tools and workshop equipment required
Hook -3438-
Engine bung set -VAS 6122-
Support device -T10323-
-T10356/5- from assembly tool -T10356-
Puller -T10373-
Thrust piece -T10376- ...
Changing bulbs in the halogen headlights
Fig. 234 In the engine compartment: covers
on the left front headlight ① dipped beam, ② main beam, side lights and daytime
running lights, ③ turn signal
First read and observe the introductory information
and safety warningsThe front headlight does not need to be removed when changing ...
Removing and installing data bus diagnostic interface -J533-
Note
When renewing the control unit, select
Renew function for the respective control unit in
Guided fault finding or
Guided functions mode
→ Vehicle
diagnostic tester.
Removing
...
© 2016-2024 Copyright www.vwgolf.org