VW Golf manuals

Volkswagen Golf Service & Repair Manual: Removing and installing bracket for onboard supply control unit -J519-, LHD vehicles

Volkswagen Golf Service & Repair Manual / Electrical system / Wiring / Control units / Removing and installing bracket for onboard supply control unit -J519-, LHD vehicles

Removing
–  With ignition switched off, disconnect earth cable from battery → Chapter.
–  Remove dash panel → General body repairs, interior; Rep. gr.70.
   
–  Cut through cable tie -arrow-.
–  Disengage fuse holder C and push to side → Chapter.
–  Disconnect connector for front parking aid warning buzzer -H22- → Chapter.
–  Disconnect connector for onboard supply control unit -J519- → Chapter.
–  Disconnect connector for parking aid control unit -J446-/park assist steering control unit -J791- → Chapter.
–  Release locking mechanism on bracket and press out bracket to remove diagnostics connector.
 

Removing and installing bracket for onboard supply control unit -J519-, LHD vehicles

–  Unscrew bolts -2, 3 and 6-.
–  Push bracket -1- forwards out of central tube until centring pins -4, 5- are disengaged.
–  Cut through cable ties -arrows-.
–  Move electrical wiring harness clear at mounting.
–  Take out bracket towards passenger compartment.
Installing
Installation is carried out in the reverse sequence.
 

Removing and installing bracket for onboard supply control unit -J519-, LHD vehicles

Removing and installing data bus diagnostic interface -J533-
  Note When renewing the control unit, select Renew function for the respective control unit in Guided fault finding or Guided functions mode &# ...

Removing and installing bracket for onboard supply control unit -J519-, RHD vehicles
Removing –  With ignition switched off, disconnect earth cable from battery → Chapter. –  ...

Other materials:

Overview of fitting locations - components not located in passenger compartment, Golf Variant RHD
1 -  Exhaust ventilation for passenger compartment Checking → Chapter Removing and installing → Chapter 2 -  Humidity sender for air conditioning system -G260- Check v ...

Engine oil specification
First read and observe the introductory information and safety warnings The engine oil used must correspond exactly to specifications. The correct engine oil is important for the function and service life of the engine. A special high quality multigrade oil has been filled at the factory and ...

Dismantling and assembling drive shaft
Special tools and workshop equipment required Thrust plate -VW 401- Thrust plate -VW 402- Press tool -VW 408 A- Press tool -VW 411- Tube -VW 416 B- Thrust washer -VW 447 H- &nbs ...

© 2016-2024 Copyright www.vwgolf.org