Volkswagen Golf Service & Repair Manual: Removing and installing Bowden cable
WARNING
It is not permissible to loosen bolts other than
those specified. |
Also, it is not permissible to perform any repair
work other than described here. |
|
|
|
|
Note
-
|
The towing bracket is not to be removed completely. |
-
|
Bolts -10- are specifically
designed to make removal difficult. |
– |
Loosen towing bracket
→ Chapter and pull it out slightly. |
– |
Use pliers to unscrew bolts -10-, and
remove cover -9-. |
– |
Turn rotating plate -8- a little, and
remove Bowden cable -7-. |
– |
Loosen bolt -5- and hexagon nut
-1-, and remove gearbox
-3- together with both Bowden cables
-2 and 7-. |
Note
|
Always use new bolts -1, 5 and 8-
and new cover -9-. |
|
The cap -6- must not be damaged
and must always be installed. |
|
Before fitting cover, the area where the seal touches it
must be cleaned. |
|
Water must be preventing from entering the swivelling
mechanism at all costs. |
|
Perform a functional check before bolting on the towing
bracket. |
|
|
|
– |
Secure gearbox -3- with new bolt
-5-, washer -4-
and hexagon nut -1-. |
– |
Attach Bowden cable -7- to rotating
plate. |
– |
Secure new cover -9- using new bolts
-8-. |
Removing
Note
Minor differences will be encountered on removal and
installation, depending on version.
...
Other materials:
Removing and installing washer fluid reservoir, »R«
Special tools and workshop equipment
required
Drip tray
Removing
–
Remove front right wheel
→ Running gear, axles, steering; Rep. gr.44.
â ...
Checking fuel pressure sender -G247-
Special tools and workshop equipment
required
Vehicle diagnostic tester
Pressure sensor tester -VAS 6394-
Test instrument adapter/DSO (3-pin) -VA ...
Introduction
This chapter contains information on the following subjects:
→ Preparing for a journey and driving safely  
→ Driving abroad  
→ Driving through water on roads 
Depending on where the vehicle is used, it could be a good idea to have an engine
and transmiss ...
© 2016-2024 Copyright www.vwgolf.org