Volkswagen Golf Service & Repair Manual: Removing and installing Bowden cable
– |
Remove release lever
→ Chapter. |
– |
Remove Bowden cable -3- from mounting
bracket -5--arrow a-. |
– |
Pull Bowden cable coupling -2- off
carrier -7--arrow e-. |
– |
Slightly pull off Bowden cable -1--arrow a-. |
– |
Open cap of Bowden cable coupling -arrow b-. |
– |
Release Bowden cable -1--arrow c- and
remove from Bowden cable coupling -2-. |
Note
In order to be able to remove or install the Bowden cable
-3-, remove the support arm
-7-
→ Chapter. |
Note
- If the Bowden cable -3- is not removed
from mounting bracket, the Bowden cable -1-
unhooks again and again when installing the Bowden cable coupling
-2-.
- The bonnet cannot be opened in this case
– |
Hook in Bowden cable -1- into Bowden
cable coupling -2--arrow a-. |
– |
Slightly pull Bowden cable off Bowden cable coupling
-arrow b-. |
– |
Close Bowden cable coupling -arrow c-. |
– |
Push Bowden cable -1- into Bowden cable
coupling -arrow d-. |
– |
Attach Bowden cable coupling -2- to
lock carrier -4--arrow e-. |
– |
Install Bowden cable -3- on mounting
bracket -5--arrow a-. |
– |
Install release lever
→ Chapter. |
– |
Before closing bonnet, check function of release lever and Bowden
cable. |
Clamp gas strut in vice in area x = 50 mm.
WARNING
Wear protective goggles when sawing.
...
Other materials:
Introduction
This chapter contains information on the following subjects:
→ Display and warning and indicator lamp
→ Operating the speed limiter
The speed limiter helps the driver not to exceed an individual stored speed when
driving forwards at speeds of approximately 30 km/h (20 m ...
Removing and installing tyre pressure sensor, tyre pressure sensor with
valve
Removing
–
Unscrew union nut -1-.
–
Remove tyre pressure sensor-2-
from bed of wheel rim.
Installing
...
Adjusting spray jets
Caution
Danger of causing damage.
Do not use any objects for cleaning spray jets!
Note
In case of uneven spray field due to impurities in th ...
© 2016-2024 Copyright www.vwgolf.org