Volkswagen Golf Service & Repair Manual: Removing and installing bonnet release lever
– |
Tighten release lever -1- and unlock
bonnet. |
– |
Insert a small screwdriver in gap between release lever
-1- and retaining clip
-2-. |
– |
Lever retaining clip -2- out of release
lever -1--arrow b- and pull release lever
off mounting bracket -3--arrow a-. |
For further work on mounting bracket -3-,
A-pillar lower trim -4- must be removed
→ General body repairs, interior; Rep. gr.70. |
l |
Lower A-pillar trim -3- is installed. |
– |
Push retaining clip -2- into release
lever -1-. |
– |
Press retaining lever -1- onto mounting
bracket -4-. |
– |
Before closing bonnet, check function of release lever and cable. |
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331-
...
Special tools and workshop equipment
required
Removing
Torque wre ...
Other materials:
Vehicles with multilink suspension
Removing
–
If fitted, remove rear left underbody trim
→ General body repairs, exterior; Rep. gr.66.
–
Remove rear tunnel cross-piece
→ General body repairs, exterior; ...
Spare wheel or temporary spare wheel
Fig. 203 In the luggage compartment: handwheel
for securing the spare wheel
First read and observe the introductory information
and safety warnings Removing the spare wheel
Open the tailgate and lift up the luggage compartment floor until it is
held in position by the side restraints ...
Assembly overview - three-point seat belt, estate, with belt tensioner
1 -
Belt guide
Removing and installing
→ Chapter
2 -
Belt inertia reel
Removing and installing
→ Chapter
3 -
Electrical wiring harness
4 -
Bolt
...
© 2016-2024 Copyright www.vwgolf.org